Cycle Electric Generator Fitted Voltage Regulators
Cycle Electric Generator Fitted Voltage Regulators
LeverbaarOp voorraad bij onze leverancier. Wij bestellen het voor je.
- Artikelnummer
- ZOD-782318
Twijfel je of dit past? Bel de werkplaats op 0182 60 35 93 of laat het monteren in Polsbroek.
Afhalen is mogelijk op Blue Bull
Meestal klaar binnen 24 uur
- Advies van onze eigen monteursVraag het gerust, we denken met je mee.
- Laten monterenIn onze werkplaats in Polsbroek.
- Afhalen in PolsbroekHaal je bestelling op bij de werkplaats.
Productinformatie
These electronic regulators replace the end bell and become a structural part of the generator. The current limiting circuit senses armature temperature and adjusts available output to allow for maximum amperes without overheating the armature. This gives you more power for faster battery recharging and cooler operation for longer generator life. Can also be used without battery. Will not fit some models with foot clutch. Installation on FL models with an OEM pre-1992 or aftermarket generator with the fins level with the motor requires the separate purchase of the ZPN 782246 end plate.
Polarizing generators and regulators The following information and instructions are for your use, so your warranty will be in effect. No warranty can be in effect if these instructions are not followed. Whenever any component of a generator charged electrical system is serviced it is necessary to re-polarize the complete system, making sure it has the correct polarity so the system will charge in the right direction. If the system is put into service with the wrong polarity it may result in burned relay points, a dead battery and damage to both the regulator and generator. Instructions: 1. To polarize a generator system with a mechanical regulator, momentarily connect a jumper wire of adequate gauge (a battery cable is ideal) between the “bat” and the “gen” terminal on the regulator after all wires have been properly connected and before starting the motor. 2. To polarize a generator system with electronic regulator/ rectifier. Before mounting the generator of the vehicle, place the generator on a non conducting work surface (like a wooden bench) and connect the positive terminal of a battery to the armature terminal of the generator. Then momentarily “flash” the negative battery terminal to the generator field terminal.